Aidan Monaghan
Physicist Steven E. Jones has revealed abundant evidence that indicates the
presence of an extreme incendiary material known as thermite, apparently
utilized within the World Trade Center towers that collapsed on September
11, 2001. Thermite is a substance that can achieve temperatures of 4500
degrees Fahrenheit within seconds upon ignition and can penetrate and
destroy the most durable steel materials available.
"Grayish white aluminum oxide ... streaming away from the reaction sites
...consistent with the use of thermite."
- Steven E. Jones - Physicist
"Mike Pecoraro ... worked ... deep below the tower ... the room they
were working in began to fill with a white smoke"
- Chief Engineers Association
http://www.chiefengineer.org/article.cfm?seqnum1=1029
Unusual clouds and streams of white smoke originating at the World Trade
Center towers were photographed moments before and during the collapse of
each tower.


Large amounts of possibly white aluminum oxide dust, streaming skyward approximately 90 seconds prior to the collapse of WTC 2:



The following video captures reveal white smoke also emerging from the base
of World Trade Center building 1 during its collapse:
Actual building demolition which visually corresponds with the above
depiction:

White hot thermite reaction and streaming white aluminum oxide dust,
produced by a thermite weld (left) and a similar bright white flame and
streaming white smoke, within a region of WTC 2 from where molten material
flowed moments later:

Molten material that strongly resembles molten iron produced by thermite
reactions, emerging from the 81st floor of WTC 2, moments before its
collapse.
This event at WTC 2 also coincided with the appearance of white smoke rising
from the bottom of this same building, as seen earlier.

Molten iron created by an actual thermite reaction:

Molten material deposit recorded by photographer Alan Chin, 20 minutes after
the collapse of WTC 2:

Potentially white aluminum oxide dust streaming away from a WTC 1 core column end, possibly severed by thermite:
Eroded WTC steel samples exhibiting sulfidation, recovered within the
collapse zones of WTC 7 and one of the WTC towers (seen below).
The Journal of the Minerals, Metals and Materials Society states:
""Rapid deterioration of the steel was a result of heating with oxidation in
combination with intergranular melting due to the presence of sulfur. The
formation of the eutectic mixture of iron oxide and iron sulfide lowers the
temperature at which liquid can form in this steel."

Physicist Steven Jones introduces the thermite hypothesis ignored by
official investigations, that can explain the unusual evidence seen above:
"There is a straightforward way to achieve 1000°C temperatures (and well
above) in the presence of sulfur, and that is to use thermate (or a similar
variation of thermite). Thermate is a high-level thermite analog containing
sulfur developed by the military (see
http://www.dodtechmatch.com/DOD/Patent/PatentDetail.aspx?type=description&id=6766744&HL=ON).
Thermate combines aluminum/iron oxide (thermite) with barium nitrate (29%)
and sulfur (typically 2% although more sulfur could be added). The thermate
reaction proceeds rapidly and is much faster than thermite in degrading
steel leading to structural failure. Thus, both the unusually high
temperatures and the extraordinary observation of steel-sulfidation
(Barnett, 2001) can be accounted for -- if the use of thermate is allowed in
the discussion."
http://www.journalof911studies.com/volume/200609/WhyIndeedDidtheWorldTradeCenterBuildingsCompletelyCollapse.pdf
Iron rich microspheres as seen under an electron microscope, recovered from
dust located near to Ground Zero, indicating the presence of thermite
reactions within the World Trade Center complex on September 11, 2001:

http://journalof911studies.com/volume/200704/JonesWTC911SciMethod.pdf